Out of stock
Only 1 left
£14.99
Overview
Model Radio Workshop Y-Lead Servo Reverser (MRW108)
MRW108 is a variation of the original MRW08 this version has the Y" lead integrated into it. The unit can be for ailerons where the second servo is going in the wrong direction. The reverser is fitted with a button that allows you to adjust the neutral to match the neutral of the first servo.
Features
Servo movement is reversed.
25% neutral adjustment is available.
Single key is used for set-up.
LED indication of set-up.
Instructions
Plug your servos into the Y-Lead Servo Reverse Unit. Plug the flying lead into the selected channel on the receiver. The servo will operate with full travel but in the reverse direction.
Set-up
With the stick at neutral, press the SET key. The LED will light to indicate that set-up is active and the servo will cycle each side of neutral. When the servo is positioned with the required neutral, release the key. The LED will extinguish to confirm that set-up is inactive. If you accidentally go past the required position, simply go round the loop again.
If the key is pressed momentarily, the movement will be in small steps.
The unit remembers the settings and it is only necessary to perform the set-up initially and when making adjustments.
To reset the neutral to the factory default, press the SET key while switching on. The LED will light to confirm the reset and extinguish when the key is released.
If you wish to change the neutral point at any time, simply repeat the set-up procedure.
SAFETY
Please ensure that the SET key cannot be pressed accidentally while the unit is in use.
"
Features
Servo movement is reversed.
25% neutral adjustment is available.
Single key is used for set-up.
LED indication of set-up.
Instructions
Plug your servos into the Y-Lead Servo Reverse Unit. Plug the flying lead into the selected channel on the receiver. The servo will operate with full travel but in the reverse direction.
Set-up
With the stick at neutral, press the SET key. The LED will light to indicate that set-up is active and the servo will cycle each side of neutral. When the servo is positioned with the required neutral, release the key. The LED will extinguish to confirm that set-up is inactive. If you accidentally go past the required position, simply go round the loop again.
If the key is pressed momentarily, the movement will be in small steps.
The unit remembers the settings and it is only necessary to perform the set-up initially and when making adjustments.
To reset the neutral to the factory default, press the SET key while switching on. The LED will light to confirm the reset and extinguish when the key is released.
If you wish to change the neutral point at any time, simply repeat the set-up procedure.
SAFETY
Please ensure that the SET key cannot be pressed accidentally while the unit is in use.
"
Write Your Own Review
