Microaces Albatros D.V/D.Va - Deaths Head

To complete you will also need transmitter, Microaces AIO 5 Channel Receiver to match your Tx, battery and charger, adhesives etc.

Flown by Georg von Hantelmann

Microaces love of aviation history ensures that the aircraft we reproduce as kits look fantastic on static display as well as in the air.

The Microaces Albatros D.V kit replicates one of the most memorable German fighters of WWI. Manufactured by Albatros Flugzeugwerke in 1917, the D.V was the last of the line of the 'D' series aircraft with the D.Va continuing in service until the end of the war.

The livery of this particular Albatros D.V is that of Georg von Hantelmann, a German fighter ace credited with 25 confirmed victories and 5 un-confirmed, during World War I. It was notable that these victories included three opposing aces shot down within the same week.
This kit is Microaces first in 1/20th scale. The increase from our usual 1/24th has enabled us to re-create the beautiful oval cigar shape of the Albatros fuselage as well as enhance the details and structures to be even more like the full scale aircraft, without compromising on scale performance in the air.

And a swathe of high resolution 3D printing, to reproduce engine parts and weaponry, elevates this kit to an even higher level of scale than you have been used to with Microaces models.

Tyvek

The contours of the sleek fuselage are made possible with the use of Tyvek. More often used in packaging and construction, Tyvek is an extremely strong paper like material made from plastic fibres, making it light weight, printable, chemically resistant so; fantastic for a kit making application.
Brushless

Another leap forward, that is embraced by this kit, is the use of a Brushless Motor and supporting electronics. Although still operating on the convenience and safety of a 1 cell, 3.7v Lipo battery, the setup provides the smooth scale power required for a larger model.



History in the Making

So to complete the kit for radio controlled flight, all you need is an All In One (AIO) Receiver that's compatible with your transmitter.
Selecting the right receiver to complete your kit:

The Microaces AIO 5CH micro receiver (NOT INCLUDED)is available with the following protocols. If unsure, check your transmitter instruction manual to find out which protocol(s) it uses. Then select the compatible receiver protocol below to view the appropriate receiver to add to your order.
DSM2/X Compat. S-FHSS Compat. FrSky D8 Compat. FrSky D16 Compat.

Kit Content

NMicroaces AP05 5000kV Brushless Motor
1.7g Micro Rotary Servo for Aileron
SHEET PARTS 2mm laser cut Depron Airframe sheet x 2
1mm printed & laser cut foam x 3
Tyvek printed & laser cut sheet x 3
Polypropylene sheet printed & laser cut x 1
polyester sticker sheet x 1

LOOSE PARTS 0.8mm laser cut plywood sheet x 1
Rubber tires x 2
4mm dia noedymium magnets x 8
140mm x 4mm dia plastic tube x 2
500mm x 1mm x 0.4mm carbon fibre strip x 2
100mm x 1.5 mm dia carbon fibre rod
pre-shaped piano wire elevator & rudder control rods
130mm x 1.0 mm dia carbon fibre tube x 2
Vac formed parts x 1
3D printed parts x 3

Selecting the 1S Brushless Electronics Pack to complete your kit:

The Microaces 1S Brushless receiver is available with the following protocols. If unsure, check your transmitter instruction manual to find out which protocol(s) it uses. Then select the compatible receiver protocol to add to your order.

Will need suitable battery and charger (Not included)